United Security Products AVD-45c Instrukcja Obsługi Pobierz pdf (Strona 28)

14 UDC 6300 Process Controller Product Manual 1/03

2.4 Mounting, Continued

Note Model Number

Before mounting the controller, refer to the nameplate on the inside of the

case and make a note of the model number. It will help later when

selecting the proper wiring configuration.

Mounting procedure

Follow the procedure In Table 2-3 below to mount the controller.

Table 2-3 Mounting Procedure

Step Action

Mark and cut out the controller hole in the panel according to the

dimension information in Figure 2-3.

There is no minimum horizontal spacing defined.

Vertical spacing must be provided for access to the mounting kit

brackets.

Remove the screw cover and loosen the screw on the front of the

controller. Pull the chassis out of the case.

Orient the case properly and slide it through the panel hole from the

front.

Remove the mounting kit (#30755050-001) from the shipping

container, and install the kit as follows:

• Install the screws into the threaded holes of the clips.

• Insert the prongs of the clips into the two holes in the top and

bottom of the case.

• Tighten both screws to secure the case against the panel.

• Carefully slide the chassis assembly into the case, press to close

and tighten the screw. Replace the screw cover.

In addition to the mounting kit, a Rear Terminal Cover Kit

(#30755496-001) is also provided.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 301 302

Brak uwag

United Security Products AVD-45c Instrukcja Obsługi Strona 28